Winland-electronics EA800-ip Manual de usuario descargar pdf (Pagina 28)

28 D-011-0152

Programming

Accessing the MAIN MENU for Programming

1. If not already powered up, apply power to the EA800 console. During the boot process:

■ The Winland Electronics splash screen is displayed.

■ The system verifies flash memory, as indicated by FLASH BOOT at the bottom of the screen.

■ The About EA800 screen is displayed.

■ The MONITORING screen is displayed. UNLOCK appears above the F1 soft key.

2. Follow the steps below to unlock the keypad and access the MAIN MENU screen.

Note: If the password entered was incorrect, the INVALID PASSWORD screen is displayed. If this happens, press

the OK soft key (F3) to try again. The 0800 password is a permanent password that can always be used

to unlock the console even if a different password has been set.

Note: Because there are no sensors programmed into the EA800 console the buzzer will sound when the

30 minute timer reaches 00:00 seconds. Press to temporarily silence the buzzer.

You can now access the MAIN MENU programming functions.

Configuring System Parameter Settings

Configuring the system settings consists of selecting date and time display format, setting sensor data collection

frequency, and enabling or disabling the audible alarm. The default system configuration parameter settings are

shown on page 13. To configure the system settings, do the following:

1. Unlock the console and access the MAIN MENU.

2. When programming, use the arrow keys, the Enter key , and the three soft keys to advance through the

menus and enter the appropriate information.

0800

Example shown, set values as

appropriate for your system.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 59 60

Sin comentarios

Winland-electronics EA800-ip Manual de usuario Pagina 28